 |
Banding at
the Top of the Page
|
| |
|
Some prints may have banding in
the first 2-3 centimeters or swaths. This kind of problem normally
happens at the top of the page (the rest of the print is not affected),
because the error-hiding algorithm cannot be applied at the beginning
of the print in certain circumstances. This depends on the Take-Up
Reel installation settings, the media used and the plot margins
selected.
To prevent banding at the top of the page, the Printer should be
configured as follows:
|
| |
|
1. Take-Up reel installed
and loaded (only for customers that have a Take-Up Reel, if not got
to the following step).
2. Select the paper margins as normal (only for customers
which use the extended margin PPD in the driver, if not go to the
following step).
3. If Heavy Coated media is being used, use the Front
Panel to select Heavy Coated Economy with Normal paper margins. Other
alternatives are either to add a 2.5 cm margin at the beginning of
the print or switch to any other type of media. |
| |
