Scan-axis shutdown - usually a paper-jam caused
by a blockage of the Scan-axis System.
corrective action
Check that there are no obstacles in the
Scan-Axis which stops the Carriage from moving freely.
corrective action
Too much friction in the Slider Rod, try
lubricating the Slider Rod.
corrective action
The Carriage is bumping into the Service Station.
If the Carriage is stuck at the right hand side of the Printer
and cannot be moved out to the center of the Print Platen it
is because the Service Station cannot uncap the printheads.
In this case replace the Service
Station Assembly.
corrective action
Check that the belt is correctly installed
and not damaged.
corrective action
Check that the Turnaround Pulley is correctly
installed.
