hp designjet 90/120/130 series printers

select printer | 90/120/130 series | disassembly | disassembly instructions

hp designjet 90/120 and 130 series printers

» disassembly instructions

» disassembly instructions

» center cover

» right end cover

» left end cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage (120/120nr)
» carriage (90/90r/ 130/130nr)

» carriage belt

» starwheel assembly

» print platen assembly

» ramp motor assembly

» pivot assembly

» feed roller assembly

» pick assembly

» inner paper guide

» paper-axis motor
» bypass platen
» bypass platen actuator (90/90r/130/130nr)

» disassembly videos



	» send feedback or comments

carriage motor



	Switch off the product and remove the power cable.


			1. Remove the Center Cover

			2. Remove the Right End Cover

			3. Remove the Left End Cover

			4. Disconnect the cable from the Carriage Motor.

			5. Release the Belt from the Carriage Motor by pushing in the Turnaround Assembly (right hand side of the printer) and at the same time releasing the Belt from the Motor on the left hand side of the printer.

			6. Remove 2 T-10 screws that secure the Carriage Motor.

			7. Remove the Carriage Motor from the Printer (needs to be removed from underneath).


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company