hp designjet 90/120/130 series printers

select printer | 90/120/130 series | disassembly | disassembly instructions

hp designjet 90/120 and 130 series printers

» disassembly instructions

» disassembly instructions

» center cover

» right end cover

» left end cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage (120/120nr)
» carriage (90/90r/ 130/130nr)

» carriage belt

» starwheel assembly

» print platen assembly

» ramp motor assembly

» pivot assembly

» feed roller assembly

» pick assembly

» inner paper guide

» paper-axis motor
» bypass platen
» bypass platen actuator (90/90r/130/130nr)

» disassembly videos



	» send feedback or comments

encoder strip



	Switch off the product and remove the power cable.


			1. Remove the Center Cover

			2. Remove the Right End Cover

			3. Remove the Left End Cover

			4. Release the Encoder Strip from the left hand side of the Printer.

			5. Release the Encoder Strip from the right hand side of the Printer.

			6. Gently slide out the Encoder Strip through the Carriage Assembly and remove from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company