3. Release the Tubes
Bracket from the Ink Supply Station by pushing the clips inwards and
lifting up the Bracket.
4. Remove 1 T-10
screw that secures the Trailing Cable Support to the Carriage Assembly.
Release the Trailing Cable Support from the Carriage Assembly.
5. Remove 1 T-10
screw that secures the Tube Crane to the Carriage Assembly.
6. Open the Printhead
Cover and remove 2 T-8 screws that secure the Tube Crane to the Carriage
Assembly.
7. Lift up the Tube
Crane to release the PH Cover from the Carriage Assembly and remove
from the Printer.
8. Release the Ink
Supply Tubes from the Raceway Holder and remove from the Printer.
After installing NEW Ink Supply Tubes, make sure that you prime the tubes
(Refer to "Set Flag to Prime Tubes" in the "Utilities" Section).
