hp designjet 90/120/130 series printers


			1. Remove the Center Cover

			2. Remove the Right End Cover

			3. Remove the Left End Cover

			4. Remove the Electronics Module

			5. Remove the Power Supply Unit

			6. Remove the Service Station

			7. Remove the Ink Supply Tubes

			8. Release the Belt from the Carriage Motor by pushing in the Turnaround Assembly (right hand side of the printer) and at the same time releasing the Belt from the Motor on the left hand side of the printer).

			9. Remove 3 T-10 screws that secure the Trailing Cable Clip to the Chassis.

			10. Release the Trailing Cable Clip from the Chassis.

			11. Release the Trailing Cable from the Chassis.

			12. Slide the Carriage Assembly to the right and out of the Printer.

			13. If the Carriage Assembly is to be replaced, make sure that you remove the belt (in order to install it on the new carriage). To remove the belt see carriage belt.



	If the Carriage is replaced by a new one, make sure that you perform the PRS Adjustment procedure.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company