hp designjet 90/120/130 series printers

select printer | 90/120/130 series | disassembly | disassembly instructions

hp designjet 90/120 and 130 series printers

» disassembly instructions

» disassembly instructions

» center cover

» right end cover

» left end cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage (120/120nr)
» carriage (90/90r/ 130/130nr)

» carriage belt

» starwheel assembly

» print platen assembly

» ramp motor assembly

» pivot assembly

» feed roller assembly

» pick assembly

» inner paper guide

» paper-axis motor
» bypass platen
» bypass platen actuator (90/90r/130/130nr)

» disassembly videos



	» send feedback or comments

ramp motor assembly



	Switch off the product and remove the power cable.


			1. Remove the Center Cover

			2. Remove the Left End Cover

			3. Remove the Starwheel Assembly

			4. Remove the Print Platen Assembly

			5. Remove 2 T-10 screwa that secure the Front Left Bracket.

			6. Remove the Front Left Bracket from the Printer.

			7. Disconnect the Ramp Motor cable.

			8. Remove 1 T-10 screw from the Ramp Motor Assembly.

			9. Remove the Ramp Motor Assembly from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company