| |
bypass platen actuator (applicable to designjet 90/90r/130/130nr)
|
 |
|
|
|
 |
|
|
| 1. Remove the Cleanout Assembly |
| |
| 2. Remove the Top Cover |
| |
| 3. Remove the Center Cover |
| |
| 4. Remove the Right End Cover |
| |
| 5. Remove the Left End Cover |
| |
| 6. Remove the Electronics Module |
| |
| 7. Remove the Power Supply Unit |
| |
| 8. Remove the Service Station |
| |
| 9. Remove the Encoder Strip |
| |
| 10. Remove the Ink Supply tubes |
| |
| 11. Remove the Carriage Assembly |
| |
| 12. Remove the Starwheel Assembly |
| |
| 13. Remove the Print Platen Assembly |
| |
| 14. Remove the Pivot Assembly |
| |
| 15. Remove the Feed Roller Assembly |
| |
| 16. Remove the Pick Assembly |
| |
| 17. Remove the Inner Paper Guide |
| |
| 18. Remove the Bypass Platen |
| |
 |
|
19. Remove 1 T-10 screw that secures the Right
Bracket to the Chassis. |
| |
|
|
 |
20. Lift the Right Bracket out of the Printer. |
| |
|
 |
21. Release the Spring from the Bypass Platen
Actuator. |
| |
|
 |
22. Remove the Bypass Platen Actuator from
the Printer. |
| |
