|
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||||||||||||||
|
 |
Printhead Status Messages While Replacing
The following are the Printhead status messages that may be displayed while replacing the Printheads.
Reseat
In this situation, select the Printhead replacement option through the Front Panel but do NOT remove the Printheads. If this status message continues to appear then remove the Printheads and install them again.
Remove
The Printhead is not a suitable type for use in printing (for example, a Setup Printhead).
Missing
No Printhead has been detected in that Carriage stall. If a Printhead is installed in the Carriage stall when this status message is shown:
1. Reseat the Printhead, making sure it is installed correctly.
2. Clean the Carriage and Printhead flex circuits using the Carriage Interconnect Wiper.
3. Replace the Printhead.
4. Perform the Electronic Systems Test.
If all 8 Printheads are installed but have the Status message "Missing", it is possible that the Carriage Assembly is faulty.
|
|||||||||||||||||||||||
|
|||||||||||||||||||||||||