Introduction

The following is a list of all internal Service Utilities available in the Printers. Instructions for entering the Service Utilities menu are given on Entering the Service Utilities Menu.

1. Turn Drive Roller

The purpose of this Service Utility is to rotate the Drive Roller and the Overdrive in order to clean them.

2. Prime Tubes

The purpose of this Service Utility is to Prime the Tubes when the Ink Tubes are NOT new and they need to be re-primed or automatic priming was not completed correctly.

3. Set SN

The purpose of this Service Utility is to set the Serial Number of the Printer.

4. Reset Life Counters

The purpose of this Service Utility is to reset the internal life counters. There are two submenus that allow you to:

5. Diagnostic Print

The purpose of this Service Utility is to print the Diagnostic Print in order to identify image quality problems.

6. Sleep Mode

The purpose of this Service Utility is to enable/disable the sleep mode so that the Printer is never switched Off automatically if not used for a certain period of time (one hour by default).

7. Replace Cutter

The purpose of this Service Utility is to move the Carriage to a position where the Cutter can be replaced easily.

8. Set RTC Clock

The purpose of this Service Utility is to set the Real Time Clock (RTC) of the Printer.

9. Carriage Setup

The purpose of this Service Utility is to reset the ink short thresholds after replacing the Carriage PCA.