hp designjet 10ps, 20ps, 30, 30n and 50ps printers

select printer | 10ps/20ps/30/30n/50ps | disassembly | disassembly instructions

hp designjet 10ps, 20ps, 30, 30n and 50ps printers

» disassembly instructions

» disassembly instructions

» center cover

» right end cover

» left end cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage assembly

» carriage belt

» starwheel assembly

» ramp motor assembly

» output separator

» output mechanism assembly

» paper-axis motor drive assembly

» pick assembly

» feed roller assembly

» pinch assembly

» lower paper guide

» inner paper guide

» disassembly videos



	» send feedback or comments

center cover

Switch off the product and remove the power cable.

1. Unclip the Top Cover and remove from the Printer.

2. Release the Ink Supply Tubes from the Tubes Holder. Remove the Tubes Holder from the Printer.

3. Release the Tubes from the retaining clips in the Center Cover.

4. Remove 4 T-10 screws that secure the Center Cover to the Printer.

5. Remove the Center Cover.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company