hp designjet 10ps, 20ps, 30, 30n and 50ps printers

select printer | 10ps/20ps/30/30n/50ps | disassembly | disassembly instructions

hp designjet 10ps, 20ps, 30, 30n and 50ps printers

» disassembly instructions

» disassembly instructions

» center cover

» right end cover

» left end cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage assembly

» carriage belt

» starwheel assembly

» ramp motor assembly

» output separator

» output mechanism assembly

» paper-axis motor drive assembly

» pick assembly

» feed roller assembly

» pinch assembly

» lower paper guide

» inner paper guide

» disassembly videos



	» send feedback or comments

ink supply station

Switch off the product and remove the power cable.

1. Remove the center cover

2. Remove the right end cover

3. Disconnect the Ink Supply Station Cable from the Main PCA.

4. Release the Tubes Bracket from the Ink Supply Station by pushing the clips inwards and lifting up the Bracket.

5. Remove 2 T-10 screws that secure the Ink Supply Station.

6. Slide the Ink Supply Station to the left to release it from the securing clips.

7. Remove the Ink Supply Station from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company