This firmware error code is related
to the detection of the Printhead cleaners by the line sensor. It
always happens during initialization, while checking the Printhead
Cleaners. In most case, it is a problem of incorrectly inserted Printhead
Cleaners, but it can also be caused by an incorrectly assembled Service
Station.
Corrective Action:
Try the following:
-Remove the Printhead Cleaners and reinsert
them again.
- If the error still persists, perform the Service
Station Calibration.
-If the error still persists, an onsite visit is necessary to repeat
the calibration or to change the Service Station assembly or the
Carriage Assembly.
