hp designjet 70/100/100plus/110plus printers

select printer | 70/100/100plus/110plus | disassembly | disassembly instructions

hp designjet 70/100/100plus/110plus printers

» disassembly instructions

» dissasembly instructions

» dissasembly videos

» center cover

» right end cover

» left end cover

» ink supply station cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage assembly

» carriage belt

» starwheel assembly

» print platen assembly

» ramp motor assembly

» pivot assembly

» feed roller assembly

» pick assembly

» inner paper guide



	» send feedback or comments

carriage motor

Switch off the product and remove the power cable.

1. Remove the Center Cover

2. Remove the Right End Cover

3. Remove the Left End Cover

4. Disconnect the cable from the Carriage Motor.

5. Release the Belt from the Carriage Motor by pushing in the Turnaround Assembly (right hand side of the printer) and at the same time releasing the Belt from the Motor on the left hand side of the printer.

6. Remove 2 T-10 screws that secure the Carriage Motor.

7. Remove the Carriage Motor from the Printer (needs to be removed from underneath).


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company