8. Release the Belt
from the Carriage Motor by pushing in the Turnaround Assembly (right
hand side of the printer) and at the same time releasing the Belt
from the Motor on the left hand side of the printer).
9. Release the Trailing
Cable Clip from the Chassis.
10. Release the
Trailing Cable from the Chassis.
11. Slide the Carriage
Assembly to the right and out of the Printer.
12. If the Carriage
Assembly is to be replaced, make sure that you remove the belt (in
order to install it on the new carriage). To remove the belt see carriage
belt.
If the Carriage is replaced by a new one, make
sure that you perform the PRS Adjustment procedure.
