select printer | 70/100/100plus/110plus | disassembly | disassembly instructions
hp designjet 70/100/100plus/110plus printers
» disassembly instructions
  » dissasembly instructions
» dissasembly videos
» top cover
» center cover
» right end cover
» left end cover
» ink supply station cover
» ink supply station
» electronics module
» power supply unit
» service station
» front panel
» encoder strip
» carriage motor
» cleanout assembly
» ink supply tubes
» carriage assembly
» carriage belt
» starwheel assembly
» print platen assembly
» ramp motor assembly
» spittoon
» pivot assembly
» feed roller assembly
» pick assembly
» inner paper guide
» OOPS sensor
 
» send feedback or
comments
 
service station
  
 
     
Switch off the product and remove the power cable.
   
  1. Remove the Center Cover
   
  2. Remove the Right End Cover
   
  3. Remove the Electronics Module
   
  4. Remove the Power Supply Unit
   
5. Remove 2 screws that secure the Reinforcement Bracket. remove the Reinforcement Bracket from the Printer.
   
6. Disconnect the Service Station Cable.
   
7. Uncap the Carriage Assembly by turning the Service Station Motor clockwise.
   
8. Move the Carriage Assembly out of the Service Station.
   
9. Release the Encoder Strip from the Encoder Strip Holder.
   
10. Remove 1 T-10 screw that secures the Encoder Strip Holder on the right hand side of the Printer.
   
11. Remove the Encoder Strip Holder from the Printer.
   
12. Slide the Service Station out of the Printer.
   
© 1994-2006 Hewlett-Packard Company