select printer | 70/100/100plus/110plus | disassembly | disassembly instructions
hp designjet 70/100/100plus/110plus printers
» disassembly instructions
  » dissasembly instructions
» dissasembly videos
» top cover
» center cover
» right end cover
» left end cover
» ink supply station cover
» ink supply station
» electronics module
» power supply unit
» service station
» front panel
» encoder strip
» carriage motor
» cleanout assembly
» ink supply tubes
» carriage assembly
» carriage belt
» starwheel assembly
» print platen assembly
» ramp motor assembly
» spittoon
» pivot assembly
» feed roller assembly
» pick assembly
» inner paper guide
» OOPS sensor
 
» send feedback or
comments
 
ink supply station
  
 
     
Switch off the product and remove the power cable.
   
  1. Remove the Center Cover
   
  2. Remove the Right End Cover
   
  3. Remove the ISS Cover
   
4. Release the Plastic Cover protecting the Electronics Module.
   
5. Remove 1 T-10 screw securing the Plastic Cover. Remove the Plastic Cover from the Printer.
   
6. Disconnect the Ink Supply Station Cable from the Main PCA.
   
7. Release the Tubes Bracket from the Ink Supply Station by pushing the clips inwards and lifting up the Bracket.
   
8. Remove 2 T-10 screws that secure the Ink Supply Station.
   
9. Rotate the Ink Supply Station upwards and then to the left to release it from the securing clips.
   
10. Remove the Ink Supply Station from the Printer.
   
© 1994-2006 Hewlett-Packard Company