select printer | 70/100/100plus/110plus | disassembly | disassembly instructions
hp designjet 70/100/100plus/110plus printers
» disassembly instructions
  » dissasembly instructions
» dissasembly videos
» top cover
» center cover
» right end cover
» left end cover
» ink supply station cover
» ink supply station
» electronics module
» power supply unit
» service station
» front panel
» encoder strip
» carriage motor
» cleanout assembly
» ink supply tubes
» carriage assembly
» carriage belt
» starwheel assembly
» print platen assembly
» ramp motor assembly
» spittoon
» pivot assembly
» feed roller assembly
» pick assembly
» inner paper guide
» OOPS sensor
 
» send feedback or
comments
 
left end cover
  
 
     
Switch off the product and remove the power cable.
   
  1. Remove the Center Cover
   
2. Disconnect the Front Panel cable from the rear of the Printer.
   
3. Remove 1 T-10 screw from the Rear Left Trim.
   
4. Remove the Rear Left Trim from the Printer.
   
5. Remove 1 T-10 screw from the Left Side Bracket.
   
6. Release the clips that secure the Left End Cover to the Printer (use a flat-blade screwdriver if necessary).
   
7. Remove the Left End Cover from the Printer.
   
© 1994-2006 Hewlett-Packard Company