hp designjet 70/100/100plus/110plus printers

select printer | 70/100/100plus/110plus | disassembly | disassembly instructions

hp designjet 70/100/100plus/110plus printers

» disassembly instructions

» dissasembly instructions

» dissasembly videos

» center cover

» right end cover

» left end cover

» ink supply station cover

» ink supply station

» electronics module

» power supply unit

» service station

» encoder strip

» carriage motor

» cleanout assembly

» ink supply tubes

» carriage assembly

» carriage belt

» starwheel assembly

» print platen assembly

» ramp motor assembly

» pivot assembly

» feed roller assembly

» pick assembly

» inner paper guide

» OOPS sensor



	» send feedback or comments

OOPS sensor

Switch off the product and remove the power cable.

1. Remove the Center Cover

2. Remove the Right End Cover

3. Remove the Electronics Module

4. Remove the Power Supply Unit

5. Remove the Service Station

6. Disconnect the OOPS Sensor Cable.

7. Remove the Spring that secures the OOPS Sensor.

8. Press the OOPS Sensor clips inwards to release it.

9. Remove the OOPS Sensor (including the cable) from the Printer.

Check if any Cable Ties need to be cut before removing the OOPS Sensor.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company