hp designjet 70/100/100plus/110plus printers

» disassembly instructions

electronics module

Switch off the product and remove the power cable.

1. Remove the Center Cover

3. Release the Plastic Cover protecting the Electronics Module.

4. Disconnect ALL the cables from the Main PCA.

5. Remove 3 T-10 screws that secure the Electronics Module and the Power Supply Unit to the Printer.

6. Remove the Plastic Cover from the Printer.

7. Remove 1 T-10 screw that secures the Electronics Module.

8. Release the plastic sheet that secures the Trailing Cable to the back of the Electronics Module.

9. Slide out the Electronics Module and the Power Supply Unit (as one assembly) to the right.

10. Slide the Power Supply Unit upwards to release it from the Electronics Module.

11. Remove the Electronics Module from the Printer.

Check if cable ties need to be cut before separating the PSU and EM.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company