select printer | 70/100/100plus/110plus | disassembly | disassembly instructions
hp designjet 70/100/100plus/110plus printers
» disassembly instructions
  » dissasembly instructions
» dissasembly videos
» top cover
» center cover
» right end cover
» left end cover
» ink supply station cover
» ink supply station
» electronics module
» power supply unit
» service station
» front panel
» encoder strip
» carriage motor
» cleanout assembly
» ink supply tubes
» carriage assembly
» carriage belt
» starwheel assembly
» print platen assembly
» ramp motor assembly
» spittoon
» pivot assembly
» feed roller assembly
» pick assembly
» inner paper guide
» OOPS sensor
 
» send feedback or
comments
 
print platen assembly
  
 
     
Switch off the product and remove the power cable.
   
  1. Remove the Center Cover
   
  2. Remove the Right End Cover
   
  3. Remove the Left End Cover
   
  4. Remove the Starwheel Assembly
   
5. Release the Belt from the Print Platen Assembly.
   
6. Remove 1 T-10 screw that secures the Spring Idler. Remove the Spring Idler from the Printer.
   
7. Release the locking mechanism from the left hand side of the Printer.
   
8. Release the locking mechanism from the right hand side of the Printer.
   
9. Slide out the complete Print Platen Assembly.
   
© 1994-2006 Hewlett-Packard Company