hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

exit roller shield



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Profile



			2. Remove the » Guide Plate



			3. Remove the » Rear Cover



			4. Remove the 2 rear guide pins for the Guide Plate.



			5. Remove the left and right hinges for the Top Profile.



			6. Loosen 16 screws on the rear side of the Exit Roller Shield.



			7. Gently remove the Exit Roller Shield from the scanner. Be careful NOT to bend it or damage it while removing.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company