hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» lamp sensor

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

lamp sensor



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Cover



			2. Remove the » Guide Plate



			3. Remove the » Glass Plate



			4. Remove the » Left Cover



			5. Remove the » Right Cover



			6. Remove the » Bottom Cover



			7. Remove the » Mirror Chassis



			8. Remove the screw that secures the Lamp Sensor.



			9. Disconnect the cable from the Lamp Sensor and remove from the scanner.



	After installing the Lamp Sensor, you must adjust the potentiometer on the Driver Board.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company