hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

fluorescent lamp



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Cover



			2. Remove the » Guide Plate



			3. Remove the » Left Cover



			4. Remove 1 screw from the Lamp Socket.



			5. Remove the Lamp Socket and slide out the Fluorescent Lamp.



	Take care not to touch the Stitching Wire while removing or installing the Fluorescent Lamp. Also take care that the Fluorescent Tube does not get caught on the Sensor Cable.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company