hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» top cover

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

top cover



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the 2 screws along the lower edge of the Top Profile.



			2. Pull the front part of the Top Cover away from the scanner in order to release the upper part of the Top Cover.



			3. Lift up the Top Cover and remove from the scanner.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company