hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» glass plate

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

glass plate



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Guide Plate



			2. Remove 1 screw from each side of the Glass Plate.



	Take note of the orientation of the bearings when removing the Glass Plate.



			3. Carefully lift up the Glass Plate and remove from the scanner.



	Always clean the glass before replacing the Glass Plate.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company