hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» camera lens

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

camera lens



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Cover



			2. Remove the » Camera Board



			3. Remove the » Camera Motor



			4. Remove 3 screws that secure the Camera Chassis.



			5. Release the 3 springs securing the Camera Chassis.



			6. Remove the Camera Lens from the scanner.



	Make sure you perform the Camera Adjustment procedure after replacing the Camera Lens.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company