hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

mirror chassis



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Cover



			2. Remove the » Guide Plate



			3. Remove the » Glass Plate



			4. Remove the » Left Cover



			5. Remove the » Right Cover



			6. Remove the » Bottom Cover



			7. Remove 2 screws from each plastic foot (only the 2 rear ones).



			8. Remove the plastic feet.



			9. Remove 2 nuts from each side of the Mirror Chassis.



			10. Remove the 2 locating screws from both sides of the Mirror Chassis.



			11. Rotate the Mirror Chassis towards you, lift up and remove from the scanner.



	Always clean the mirrors before replacing the Mirror Chassis.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company