hp designjet scanner series

select printer | scanner series | disassembly instructions

hp designjet scanner series

» disassembly instructions

» disassembly instructions

» introduction

» entry roller shield

» exit roller shield

» camera board

» camera motor

» power supply unit

» driver board

» main electronics board

» smart card reader

» interface board card

» interface board

» stepper motor

» fluorescent lamp

» media detector wires

» media sensors

» bottom cover

» mirror chassis

» reflector assembly

» stitching wire

» white background assembly

» thickness sensor

» part number selector

» exploded views

» service manual

» general information



	» send feedback or comments

camera board



	Switch the printer, scanner and the PC OFF, and disconnect them from the power source prior to performing any maintenance.



			1. Remove the » Top Cover



			2. Remove the » Camera Motor



			3. Disconnect the cable from the Camera Board that needs to be replaced.



			4. Remove 4 nuts that secure the Camera Motor.



			5. Remove the Camera Board from the scanner.



	Make sure you perform the Camera Adjustment procedure after replacing the Camera Board.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company