hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Electronics Module

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Left Hand Cover » Left Hand Cover.
			2. Disconnect ALL the cables from the Electronics Module.
			3. Remove 1 T-10 screw (Type B) from the top of the Electronics Module.
			4. Remove 1 T-10 screw (Type B) from the back of the Electronics Module.
			5. Loosen 1 T-10 screw (Type B) just below the Electronics Module.
			6. Lift the Electronics Module up and towards the right and remove from Printer.
			Installing the Electronics Module NOTE: When installing the Electronics Module, make sure that you insert the tab on the Printer into the slot in the Electronics Module.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company