hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Print Platen

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Cutter Assembly » Cutter Assembly.
			2. Remove the Cutter Guide Bracket » Cutter Guide Bracket .
			3. Remove the following screws (Type G) from the Print Platen: 24 Screws (T-8) for the 24" model. 36 Screws (T-8) for the 42" model.
			4. Pull the tabs out slightly and lift each piece of the Print Platen from the Printer. NOTE: The Print Platen is split into 2 pieces on the 24" model and into 3 pieces on the 42" model.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company