hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Pinch-Arm Mechanism

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Back Platen (make sure the Pinch-Arm Lever is in the UP Position) » Back Platen.
			2. Remove ALL the Pinch-Arms » Pinch-Arm.
			3. Remove 1 T-15 screw (Type E) that attaches the Cam to the Lever.
			4. Remove 1 T-15 screw from the left hand side of the Cam.
			5. Open the Media Guide by unclipping it.
			6. While pulling the Media Clip down, move the complete assembly to the left, towards you and then to the right and remove completely.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company