hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Interconnect Cable

	WARNING: Switch off the printer and remove the power cable.
			1. Remove the Left Hand Cover » Left Hand Cover.
			2. Remove the Right Hand Cover » Right Hand Cover.
			3. Remove the Electronics Module » Electronics Module.
			4. Remove the Left Encoder Holder » Left Encoder Holder.
			5. Remove the Service Station » Service Station and Aerosol Fan.
			6. Remove the Service Station Holder » Service Station Holder .
			7. Slide the Cable out of the Printer from the right hand side. NOTE: Make sure when removing the cable that it does NOT scratch against the edge of the beam. NOTE: Make sure that the Plastic Protector is NOT removed while removing the Cable.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company