hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Back Platen

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Back Platen

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Spindle.
			2. Make sure the Media Lever is in the UP Position.
			3. Unclip the Media Sensor Cover and remove from the Printer.
			4. Unclip the Media Sensor from underneath the Back Platen.
			5. Remove 2 T-15 screws (Type E) from the Back Platen.
			6. Remove the Back Platen by pulling it evenly towards you. NOTE: Make sure that the Media Sensor is not attached to the Back Platen to prevent pulling the cable and breaking the sensor.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company