hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Left Encoder Holder

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Left Hand Cover » Left Hand Cover.
			2. Remove 1 T-15 screw (Type E) from the Left Encoder Holder (attaches the Encoder Strip to the Holder).
			3. Release the Encoder Strip from the left hand side. NOTE: The Encoder Strip is sharp so be careful when touching it.
			4. Disconnect the Trailing Cable and unclip the Ferrite and remove.
			5. Remove the Electronics Module » Electronics Module.
			6. Remove 2 T-20 screws (Type A) from the Left Encoder Holder.
			7. Remove the Left Encoder Holder, making sure that you first unclip both the Trailing Cable and the Interconnect Cable.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company