hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Ink Supply Station

	WARNING: Switch off the printer and remove the power cable. NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Remove the Ink Cartridges.
			2. Remove the Right Hand Cover » Right Hand Cover.
			3. (Connectors P2 and P4) from the Interconnect PCA.
			4. Release the Tubes Bracket from the Ink Supply Station by pushing the clips inwards and lifting up the Bracket.
			5. Remove 1 T-15 screw (Type E) from the top of the Assembly.
			6. Remove the Ink Supply Station from the Printer. NOTE: The ISS is a complete Assembly that includes the Cartridge Holder (top) and Tray (bottom). The complete Assembly must be removed/installed together.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company