hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Service Station and Aerosol Fan

	NOTE: Refer to the table on » Screw Types for information on screw types.
			1. Perform the Service Utility "Unlock Carriage" » Unlock Carriage. NOTE: Switch off the Printer after performing this Utility.
			2. Remove the Right Hand Cover » Right Hand Cover.
			3. Manually move the Carriage out of the Service Station.
			4. Disconnect the Service Station and Aerosol Fan Cables (connectors P5 and P9) from the Interconnect PCA.
			5. Remove 2 T-15 screws (Type E) from inside the Service Station.
			6. Make sure you lift the Carriage Lock before sliding out the Service Station out of the Printer.
			7. Slide the Assembly towards you (to the right) and remove.
			Installing the Service Station/Aerosol Fan NOTE: When installing the Service Station, make sure that you line up the tabs on the Service Station with the structure of the Service Station Holder.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company