hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Fork Idler, Tensioner and Idler Pulley

	WARNING: Switch off the printer and remove the power cable.
			1. Remove the Right Hand Cover » Right Hand Cover.
			2. Remove the Left Hand Cover » Left Hand Cover.
			3. Release the tension from the right hand side of the Belt by pulling the Tensioner down and pushing it towards you to lock it into position.
			4. Release the Belt from the Scan-Axis Motor on the left hand side.
			5. Pull out the Belt from the right hand side of the Printer and remove the Idler Pulley.
			6. Unlock the Tensioner and remove from the Printer. NOTE: If it is too difficult to unlock the tensioner by hand, try using a Screwdriver (as a lever) instead.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company