select printer | 500/800 series | disassembly | disassembly instructions
hp designjet 500/800 series printers
» disassembly
  » disassembly instructions
» screw types
» Left Hand Cover
» Right Hand Cover
» Front Panel
» Window and Top Cover
» Media Deflectors
» Left End Roll-Feed
» Right End Roll-Feed
» Back Platen
» Media Sensor
» Formatter
» LAN Card
» Spittoon
» Electronics Module
» Power Supply
» Scan-Axis Motor
» Cutter Assembly
» Left Encoder Holder
» Cutter Bushing
» Cutter Guide Bracket
» Drive Roller Encoder Sensor
» Trailing Cable
» Ink Supply Station
» Interconnect PCA
» Service Station and Aerosol Fan
» Cutter Guide
» Print Platen
» Service Station Holder
» Interconnect Cable
» Ink Supply Tubes
» Vacuum Fan
» Pinch-Arm
» Pinch-Arm Mechanism
» Pinch-Arm Lever
» Pinch-Arm Sensor
» Fork Idler, Tensioner and Idler Pulley
» Encoder Strip
» Carriage Assembly
» Paper-Axis Motor
» Drive Roller
» Gear Assemblies
  » disassembly videos
» send feedback or
comments
 
» Pinch-Arm Lever Sensor

WARNING: Switch off the printer and remove the power cable.

NOTE: Refer to the table on » Screw Types for information on screw types.

 


1. Remove the Right Hand Cover » Right Hand Cover.

2. Raise the Media Lever.

3. Lift tab up and slide Right Deflector to the left and lift up.

 


4. Remove 1 T-20 screw (Type C) from the Right Deflector Bracket.



5. Remove the Right Deflector Bracket.


6. Remove 1 T-8 screw (Type G) from the Pinch-Arm Sensor.

7. Disconnect the Pinch-Arm Sensor Cable from the Interconnect PCA.
8. Remove the Pinch-Arm Sensor (including the cable).
© 1994-2006 Hewlett-Packard Company