hp designjet 500/800 series printers

select printer | 500/800 series | disassembly | disassembly instructions

hp designjet 500/800 series printers

» disassembly

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Window and Top Cover

» Media Deflectors

» Left End Roll-Feed

» Right End Roll-Feed

» Media Sensor

» Electronics Module

» Power Supply

» Scan-Axis Motor

» Cutter Assembly

» Left Encoder Holder

» Cutter Bushing

» Cutter Guide Bracket

» Drive Roller Encoder Sensor

» Trailing Cable

» Ink Supply Station

» Interconnect PCA

» Service Station and Aerosol Fan

» Cutter Guide

» Print Platen

» Service Station Holder

» Interconnect Cable

» Ink Supply Tubes

» Vacuum Fan

» Pinch-Arm Mechanism

» Pinch-Arm Lever

» Pinch-Arm Sensor

» Fork Idler, Tensioner and Idler Pulley

» Encoder Strip

» Carriage Assembly

» Paper-Axis Motor

» Drive Roller

» Gear Assemblies

» disassembly videos



	» send feedback or comments

	» Vacuum Fan

	WARNING: Switch off the printer and remove the power cable.
			1. Remove the Left Hand Cover » Left Hand Cover.
			2. Remove ALL the Media Deflectors » Media Deflectors.
			3. Disconnect the Vacuum Fan Cable from the Electronics Module.
			4. Remove the Vacuum Fan Cable from the Cutter Guide Bracket.
			5. Unclip the Vacuum Fan Assembly from underneath the Printer. NOTE: Push in the clips of the Vacuum Fan starting from the right-hand side.
			6. Remove the Vacuum Fan Assembly from the Printer. NOTE: When removing the Vacuum Fan Assembly, make sure you pull the Vacuum Fan cable through the hole in the Chassis.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company