select printer | 4000 series | disassembly | disassembly instructions
hp designjet 4000 series printers
» disassembly instructions
» Introduction
» Screw Types
» Window
» Right Cover
» Left Cover
» Top Cover
» Rear Door
» Right Connector Cover
» Left Connector Cover
» Front Panel
» Service Station
» Vacuum Fan
» Aerosol Fan
» Drop Detector
» Ink Supply Tubes and Trailing Cable
» ISS to Cartridge Cables
» Cutter Assembly
» Ink Supply Station
» APS Assembly
» Most Left Spittoons
» Middle Left Spittoons
» Encoder Strip and Encoder Sensor
» Carriage PCA
» Carriage Flex Cables
» Carriage Assembly
» Belt Assembly
» Scan-Axis Motor
» Media-Axis Motor
» Interconnect PCA
» EIO to PCA Interface Card
» Gamut PCI PCA
» Memory Module
» Main PCA Formatter
» Hard Disk Drive
» Power Supply Unit
» PrintMech PCA
» Formatter Battery
» Line Sensor
» Media Deflector
» Front Platen
» Center Platen
» Cartridge Trays
» Input Roller
» Push-Push
» Media Sensor
» Encoder Disc and Sensor
» Media Lever
» Media Lever Sensor
» Pinchwheel Assembly
» Center Guide
» Drive Roller
» Right Rollfeed Module Assembly
» Right Spindle Lever
» send feedback or
comments
 

Right Spindle Lever

Removal

These instructions explain how to remove a broken Spindle Lever and install a new one.
1. Pull out the Media Spindle from the Printer.
2. Remove the Spring from the Spindle Lever.
3. Remove one T-20 screw (Type O) that secures the Spindle Lever.
4. Remove the Spindle Lever.

Installation

1. Position the new Spindle Lever on the Printer.
2. Install one T-20 screw (Type O) to secure the Spindle Lever.
3. Place the spring on the top hook.
4. Stretch the spring and loop the spring on the bottom hook.
5. Check that the Spindle Lever is installed correctly as shown here.
© 1994-2006 Hewlett-Packard Company