select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Gamut PCI PCA

Removal

Switch off the product and remove the power cable.

1. Remove the Rear Door.

2. Remove the Left Connector Cover.

3. Remove the JetDirect Card (if installed).

4. Remove three T-15 screws (Type A) that secure the Main PCA cover.

5. Remove the Main PCA Cover from the Printer.

6. Disconnect the Trailing Cable from the Gamut PCI PCA.

7. Disconnect ALL cables connected to the Gamut PCI PCA

8. Remove one T-10 screw (Type I) that secures the Gamut PCI PCA.

9. Disconnect the Gamut PCI PCA from the Main PCA and remove from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company