Ink Supply Tubes and Trailing Cable

Removal

Switch off the product and remove the power cable.

You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and Trailing Cable at the same time. If both parts need to replaced, you MUST first replace one part and then power ON the Printer until it completely initializes. Then you can power OFF the Printer and replace the other part.

1. Remove the Right Cover.

2. Remove the Left Cover.

3. Remove the Top Cover.

4. Remove the Rear Doo.

5. Remove the Right Connector Cover.

6. Disconnect the Trailing Cable from the Interconnect PCA and the Gamut PCA.

7. Release the two plastic clips securing the Trailing Cable.

8. Press the two side of the Carriage PCA Cover and unclip from the Carriage Assembly.

9. Disconnect the Trailing Cable from the Carriage PCA.

10. Open the Carriage Cover and remove ALL the Printheads from the Carriage Assembly.

11. Remove five T-15 screws (Type G ) that secure the Ink Supply Tubes to the Carriage Assembly.

12. Remove one T-20 screw (Type B) from each plastic holder at the rear of the Printer.

13. Disconnect the Electrical Cable from the rear of the Ink Cartridge Tube Connector.

14. Disconnect the Air Tube from the Ink Supply Tubes.

15. Twist the 2 latches at the rear of the Ink Cartridge Tube Connector and release the complete assembly.

16. Remove the Ink Supply Tubes and Trailing Cable from the Printer.

Installation of the Ink Supply Tubes and Trailing Cable

After installing the NEW Ink Supply Tubes and Trailing Cable, make sure you perform the following Service Utility:

16. Reset life counter scan cycles tubes / cable.

When installing the Ink Supply Tubes and Trailing Cable on to the Top Cover, take note of the of the two red marks on the Ink Supply Tubes. These two red marks should be aligned with the first slot in the Top Cover as this will help with the rest of the installation.