select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Rear Door

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Rear Door

Removal

Switch off the product and remove the power cable.

1. Remove three T-15 screws (Type G ) from the Rear Door.

Each screw includes a washer (part number 3050-1267).

2. Open the Rear Door slightly (as shown).

3. To release the right hand hinge of the Rear Door, move the Rear Door to the right and then towards you.

4. To release the left hand hinge of the Rear Door, move the Rear Door to the right and then bend the hinge slightly (as shown).

5. Remove the Rear Door from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company