select printer | 4000 series | disassembly | disassembly instructions
hp designjet 4000 series printers
» disassembly instructions
» Window
» send feedback or
comments
 

Center Guide

Removal

Switch off the product and remove the power cable.
1. Remove the Right Cover.
2. Remove the Left Cover.
3. Remove the Right Connector .

4. Remove the Left Connector.

5. Remove the Service Station.
6. Remove the Ink Supply Station.
7. Remove the Media Sensor.
8. Disconnect ALL the cables connected to the Interconnect PCA and the Gamut PCI PCA.
9. Disconnect ALL the cables connected to the PrintMech PCA.
10. Remove four T-20 screws (Type B) that secure the Electronics Module.
11. Remove the Electronics Module from the Printer.
12. Remove one T-15 screw (Type E), that secures the Center Guide, from underneath the Printer.
13. Remove two T-15 screws (Type E), that secure the Center Guide, from the left hand side of the Printer.
14. Remove one T-15 screw (Type E ) and two T-20 (Type A), that secure the Center Guide, from the right hand side of the Printer.
15. Remove the Center Guide from the Printer.
Watch video
© 1994-2006 Hewlett-Packard Company