select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Encoder Strip and Encoder Sensor

Removal

Switch off the product and remove the power cable.

1. Remove the Right Cover.

2. Remove the Left Cover.

3. Uncap the Carriage Assembly by manually pulling out the Printhead Cleaner tray.

4. Move the Carriage Assembly out of the Service Station.

5. Remove one T-10 screw (Type I) that secures the Encoder Strip on the right hand side of the Printer.

6. Release the Encoder Strip from the locating pins on the right hand side of the Printer.

7. Release the Spring Clip from the Bracket on the left hand side of the Printer.

8. Pull the Encoder Strip out of the left hand side of the Printer.

9. Remove the Carriage PCA.

10. Remove one T-8 screw (Type L) that secures the Encoder Sensor to the Carriage Assembly.

11. Remove the plastic cover from the Encoder Sensor.

12. Remove the Encoder Sensor from the Printer.

After installing the NEW Encoder Strip and Encoder Sensor, make sure you perform the following Service Calibration: Scan-Axis Calibration.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company