select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Media Lever Sensor

Removal

Switch off the product and remove the power cable.

1. Remove the Right Cover.

2. Remove the Rear Door.

3. Remove the Right Connector Cover.

4. Remove the Service Station.

5. Remove the Front Platen.

6. Remove the Media Lever and Linkage.

7. Disconnect the Media Lever Sensor cable from the Interconnect PCA.

8. Remove five T-15 screws (Type B) that secure the Right Trim.

9. Carefully remove the Right Trim from the Printer.

10. Carefully release the clip securing the Media Lever Sensor from the Right Trim and remove from the locating pins.

11. Release the Media Lever Sensor Cable from the four clips on the Vacuum Fan.

12. Remove the Media Lever Sensor from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company