select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Encoder Disc and Sensor

Removal

Switch off the product and remove the power cable.

Please handle the Encoder Disc very carefully since any finger prints, scratches or stains could cause the Printer to malfunction.

1. Remove the Left Cover.

2. Remove the Rear Door.

3. Remove the Left Connector Cover.

4. Remove the Ink Supply Station.

5. Disconnect the Encoder Sensor cable from the PrintMech PCA.

6. Release the Encoder Sensor cable from the clip located on the Electronics Module.

7. Release the Encoder Sensor cable from the clip located on the Encoder Disc Cover.

8. Unclip the Encoder Disc Cover and remove from the Printer.

9. Remove one T-8 screw (Type D) that secures the Encoder Sensor to the Chassis.

10. Remove the Encoder Sensor from the Printer.

11. Carefully peel the Encoder Disc from the Drive Roller.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company