select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Media-Axis Motor

Removal

Switch off the product and remove the power cable.

1. Remove the Rear Door.

2. Remove the Left Connector Cover.

3. Disconnect the Media-Axis Motor cable from the PrintMech PCA.

4. Remove two T-15 screws (Type R) that secure the Media-Axis Motor.

5. Loosen two T-20 screws (Type B) that secure the Media-Axis Motor Bracket.

6. Remove the Media-Axis Motor from the Printer.

When reinstalling the parts, make sure you apply the grease (included with the support part) to the gears.

After installing the NEW Media-Axis Motor, make sure you perform the following Service Calibration: Paper Advance Calibration.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company