select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Screw Types

» Window

» Right Cover

» Left Cover

» Top Cover

» Rear Door

» Right Connector Cover

» Left Connector Cover

» Front Panel

» Service Station

» Vacuum Fan

» Aerosol Fan

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Line Sensor

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Push-Push

» Media Sensor

» Encoder Disc and Sensor

» Media Lever

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Formatter Battery

Removal

Switch off the product and remove the power cable.

1. Remove the JetDirect Card (if installed).

2. Remove three T-15 screws (Type A) that secure the Main PCA cover.

3. Remove the Main PCA Cover from the Printer.

4. Push the clip down and release the battery from the Main PCA.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company